Controls And Functions - Philips LTC 3963/51 Instructions For Use Manual

CONTROLS AND FUNCTIONS

[FRONT]
1
S
3 4 5 6 7 8 9 10 11 12 13 14 15 16
1. RESET BUTTONS
Press these buttons at the same time to clear all
(microprocessor) functions.
Press the "S" button to reset the system. (This does
not erase the stored information.)
2. CASSETTE COMPARTMENT
3. SHARPNESS CONTROL
Adjust the picture quality to hard or soft during play-
back.
4. TRACKING CONTROL
Adjust to optimize the picture quality during playback
at the 06, A18 and A30 hour speeds.
5. SLOW TRACKING CONTROL
Adjust to optimize the picture quality in the SLOW
PLAY mode, e.g. speeds over 30 hours.
6. V. LOCK CONTROL
Reduces vertical jitter in the still play mode.
7. PROGRAM BUTTON
Press to select one of the six programmable func-
tions.
8. START/STOP BUTTON
Press to start or stop the programming of a program-
mable function. (Press once to start the programming
sequence and a second time to stop (end) it.)
9. SET BUTTON
Press to select the specific value which is to be
changed with the UP/DOWN buttons.
10. DOWN BUTTON
Press to decrement, change or reverse to the
previous/lower value.
5
2 DISPLAY (See page 7)
11. UP BUTTON
12. V-POS (VERTICAL POSITION) BUTTON
13. H-POS (HORIZONTAL POSITION) BUTTON
14. ALARM INDEX BUTTON
15. ALARM RESET BUTTON
16. COUNTER RESET BUTTON
17. REC/PLAY HOURS BUTTONS
18. TIMER BUTTON
19. SUMMER TIME BUTTON
17 18 19
Press to increase, change or advance to the next
higher value.
Press repeatedly to control the vertical position of the
programmable display on the monitor.
Press repeatedly to control the horizontal position of
the programmable display on the monitor.
Press this button to cause the INDEX indicator to light,
and set the VCR to the visual search mode (press
F.FWD or REWIND during playback mode) in this
state; the start of the alarm recorded can be located.
Press to clear POWER LOSS information. When this
button is pressed, the alarm memory is cleared.
Press to clear the digital counter to "00000".
(UP): Press to increase hours to the next
higher value.
(DOWN): Press to decrease hours to the next
lower value. The tape speed will be
indicated as part of the monitor display.
Press after programming the TIMER for automatic
TIMER recording. See page 15 for TIMER program-
ming.
Press to set the summer time. See "SUMMER TIME
FUNCTION" on page 15 for details.