Table of Contents
Advertisement
Setting the Animation Mode
Pronto NG provides navigation feedback through graphical animations. Switching
pages is done with a page transition, switching from Use Mode to one of the Tools
is accompanied with a mode transition. You can enable and disable the animations
of your Pronto NG in the second Settings Page:
You can disable the animations by choosing 'None' (no animations). By
disabling all animations you use the absolute maximum of your Pronto NG's
processing speed.
When changing pages with the 'Page Only' animation, one page seems to
slide out of the screen, while the second page slides in.
The 'Mode Only' animation shifts the Pronto NG icon at the top area of the
touch screen.
With the option 'Full' you can enable both animations at the same time.
Calibrating the Touch Screen
When you first use your Pronto NG, the touch screen is already calibrated.
However, if you notice that your Pronto NG does not send out the commands in
accordance with what is indicated on the touch screen, it is advised to recalibrate
the touch screen.
Attention Never use an actual pen, pencil or other sharp object on the touch screen. Use a
1 Tap
The 'Calibration' screen appears.
2 Tap the upper left corner on the touch screen.
3 Tap the lower right corner on the touch screen.
4 Tap the upper right corner on the touch screen.
5 Tap the lower left corner on the touch screen.
The touch screen is calibrated.
-or-
Press the middle firm key, labeled
The second Settings Page appears again without calibrating the touch screen.
Note
User Guide
33
pointy object like a plastic-tipped pen or a stylus intended for use with touch
screens.
If the calibration fails, an message appears and you can follow the procedure to
calibrate the touch screen again.
Customizing Pronto NG
in the second Settings Page.
.
Advertisement
Table of Contents
