Operation - Craftsman 315.115710 Operator's Manual

WARNING:
Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or acces-
sories not recommended by the manufacturer of this
hand vac. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this hand vac for the following purposes:
 Light-duty vacuuming of dry surfaces.
NOTE: This hand vac is intended for household use only.
This product will accept Craftsman
battery packs and Craftsman
tery packs.
For complete charging instructions, see the Operator's
Manuals for your battery pack and charger models.
BATTERY PROTECTION FEATURES
Craftsman 19.2 V lithium-ion battery packs are designed
®
with features that protect the lithium-ion
maximize battery life.
If the product stops during use, recharge the battery pack.
TO INSTALL BATTERY PACK
See Figure 2, page i.
 Place the battery pack in the hand vac. Align the raised
rib on the battery pack with groove in hand vac's bat-
tery port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in
the hand vac before beginning operation.

OPERATION

19.2 V lithium-ion
®
19.2 V nickel-cadmium bat-
®
cells and
WARNING:
tool when you are assembling parts, making adjust-
ments, cleaning, or when not in use. Removing bat-
tery pack will prevent accidental starting that could
cause serious personal injury.
CAUTION:
vac, be sure raised rib on battery pack aligns with
the bottom of the hand vac and latches into place
properly. Improper installation of the battery pack
can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 3, page i.
 Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from
the hand vac.
WARNING:
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
ON/OFF SWITCH
See Figure 3, page i.
 To turn the vacuum on: Slide switch toward the front of
the vacuum.
 To turn the vacuum off: Slide switch toward the back
of the vacuum.
ADDING ATTACHMENTS
See Figures 4 - 5, page i.
The brush attachment and crevice tool can be easily snapped
into place on the hand vac.
 Turn off the vacuum.
 Insert the attachment into the front end of the vacuum
dust bowl, making sure the attachment is firmly
snapped into place.
6 - English
Always remove battery pack from your
When placing battery pack in the hand
Battery tools are always in operating