Troubleshooting - Philips HTB4150B/93 User Manual

USB
• Compatibility: Hi-Speed USB (2.0)
• Class support: USB Mass Storage Class
(MSC)
• File system: FAT16, FAT32, NTFS
• USB port: 5V
Main unit
• Power supply: 110-240 V~, 50-60 Hz
• Power consumption: 40 W
• Standby power consumption: ≤ 0.5 W
• Dimensions (WxHxD):
701 x 78 x 317 mm
• Weight: 6.8 kg
• Operating temperature and humidity:
0°C to 45°C, 5% to 90% humidity for all
climates
• Storage temperature and humidity:
-40°C to 70°C, 5% to 95%
Speakers
• Output power: 2 x 20 W RMS (10% THD)
• Speaker impedance: 4 ohm
• Speaker drivers: 2 x racetrack (1.5" x 5") +
Subwoofer
• Output power: 40 W RMS (10% THD)
• Impedance: 4 ohm
• Speaker drivers: 105mm (4") woofer
Remote control batteries
• 2 x AAA-R03-1.5 V
Laser
• Laser Type (Diode): InGaN/AIGaN (BD),
AIGaInP (DVD/CD)
• Wave length: 405 ±7 nm (BD),
660 ±10 nm (DVD), 785 ±10 nm (CD)
• Output power (Max. ratings):
20 mW (BD), 6 mW (DVD), 7 mW (CD)
, 1A
2 x 1" tweeter

9 Troubleshooting

Warning
•
Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at
www.philips.com/support.
Main unit
The buttons on the SoundStage do not work.
• Disconnect the SoundStage from the
power supply for a few minutes, then
reconnect.
• Make sure that the touch buttons surface
is not in contact with any conductive
material, like water drop, metal, etc.
Picture
No picture.
• Make sure that the TV is switched to the
correct source for the SoundStage.
No picture on a TV connected through HDMI.
• Make sure that you use a High Speed
HDMI cable to connect the SoundStage
and TV. Some Standard HDMI cables do
not display properly for some images, 3D
video, or Deep Color.
• Make sure that the HDMI cable is not
faulty. If it is faulty, replace it with a new
cable.
and then 731 on the remote
• Press
control to restore the default picture
resolution.
• Change the HDMI video setting, or wait
for 10 seconds for auto recovery (see
'Picture and video settings' on page 23).
EN
29