1
Connect the FM antenna to FM
ANTENNA on your SoundStage.
•
For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press SOURCE repeatedly to select radio
source.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message [AUTO
INSTALL...PRESS PLAY] appears on
the display panel. Press
radio stations.
3
Use the remote control to select or to
change radio stations.
Play buttons
Button
Action
/
Select a preset radio station.
or
Alphanumeric
buttons
Navigation
Left/Right: Search for a radio
buttons
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation
of radio stations.
Press and hold to erase the
preset radio station.
Manual:
1) Press
2) Press
preset.
3) Press
radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE /
Toggle between the stereo
AUDIO
and mono sounds.
EN
18
to install
.
/
to select your
again to store the
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1
Press SOURCE repeatedly to select radio
source.
2
Press .
3
Press and hold
50 kHz or 100 kHz.
MP3 player
Connect a MP3 player to play audio files.
What you need
•
An MP3 player.
•
A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO IN
connector on your SoundStage.
•
If you use 6.5mm stereo audio cable,
connect the MP3 player to your
SoundStage using a 3.5mm - 6.5mm
converter jack.
2
Press SOURCE repeatedly until [AUDIO]
appears on the display panel.
3
Press the buttons on the MP3 player to
select and play audio files.
Voole
With this player connected to the Internet, you
can stream movies and TV episodes.
1
Connect the SoundStage to the Internet
(see 'Set up the wired network' on page
12).
2
Press .
3
Select [Voole], and press OK.
» The default Voole page is displayed on
the TV screen.
to toggle between