Table of Contents
Advertisement
IT Cooling
Health and Safety
IMPORTANT
The information contained in this manual is critical to the correct operation and maintenance of the unit and should be
read by all persons responsible for the installation, commissioning and maintenance of this Airedale unit.
Safety
The equipment has been designed and manufactured to meet international safety standards but, like any mechanical/
electrical equipment, care must be taken if you are to obtain the best results.
When working with any air conditioning units ensure that the electrical isolator is switched off prior
to servicing or repair work and that there is no power to any part of the equipment.
CAUTION
Also ensure that there are no other power feeds to the unit such as fire alarm circuits, BMS circuits
etc.
Electrical installation commissioning and maintenance work on this equipment should be undertaken by competent and
trained personnel in accordance with local relevant standards and codes of practice.
A full hazard data sheet in accordance with COSHH regulations is available should this be required.
Personal Protective Equipment
Airedale recommends that personal protective equipment is used whilst installing, maintaining and commissioning
equipment.
Electrical Bonding
It is important that the components attached to the server rack are electrically bonded to earth correctly.
It is recommended that a mechanical earth strap is used at the following locations:
•
Doors
•
LogiCool InRak
•
LogiCool InRak Chilled Water Coil
•
Dual Power Supplies
Manual Handling
Some operations when servicing or maintaining the unit may require additional assistance with regard to manual
handling. This requirement is down to the discretion of the engineer.
Remember do not perform a lift that exceeds your ability.
InRak™ 300mm Technical Manual 9439563 V1.1.0_02_2017
LogiCool InRak™
3
Advertisement
Table of Contents
Need help?
Do you have a question about the LogiCool InRak and is the answer not in the manual?