Advertisement
ASSEMBLY INSTRUCTIONS CONTINUED
PLATFORM BED
NOTE 5: When screwing in bolts, tighten well, but be sure
NOT TO OVERTIGHTEN. This can cause the thread to strip thus
resulting in a poor connection.
NOTE 6: All mating parts are numbered so they correspond to
the appropriate part around the frame of the bed. you will
ensure the best possible fit if all parts are mated with the
corresponding numbered parts. While you work, be sure all
connections are flush with no gaps.
INSTRUCTIONS
1. ATTACH SIDEBEAMS TO HEADBOARD BEAM
a)Unpack components and lay them face down on the floor, so they
are in the correct orientation. Check for number markings.
b)Insert metal dowels into the pre-drilled holes in the head-
board beam, and insert Univeral Connectors into the pre-drilled
holes in the sidebeams. Feed the metal dowels through the Uni-
versal Connectors and tighten with a 6mm Allen Key.
0
2
N
E
R
I
&
H
U
Advertisement
