Kurzweil M130 User Manual page 10

Caution - Do not press or draw the piano body before bolted up
while the piano body is placed on the side panel.
1. Assembling the Stand Legs and Pedal Box
Leg(Left)
Pedal Box
2. Assembling Back Panel
Back Panel
Pedal Cable
Back Panel Set Screws
Clamps
Back Panel Screws
Leg(Right)
Pedal Box Set Bolts
13
Starting with the left stand leg, align the
holes in the Pedal Box with the holes in the
Stand Leg, then thread Pedal Box Set
Bolts into the holes.
Repeat with the right Stand Leg and tight-
en all bolts fully.
Put the cable in the Pedal Box out
Place the Back Panel on the assembled
Stand Legs.
Align the holes in the Back Panel with the
Bracket in the Stand Legs, then fasten
them by using Back Panel Set Screws as
shown.
Attach the Pedal Box to the bottom of Back
Panel and thread Back Panel Screws into
the 4 holes. them by using Back Panel Set
Screws as shown.
After placing the Clamp over the Pedal
Cable, stick it on the Back Panel then
arrange the Cable behind the Back Panel.
the 4 holes. them by using Back Panel Set
Screws as shown.