Table of Contents
Advertisement
OVERVIEW
This document gives details of how to install, test, use and maintain operation of your MF9300 fire
alarm panel.
SYSTEM OPERATION
What To Do At A Glance
The following information tells you what the various indicators, visible on the front panel, mean and
how you should react to them.
INDICATOR
GENERAL FIRE
ALARM LINE DELAY
SYSTEM FAULT
DISABLEMENT
TEST
REMOTE SIGNAL ISOLATE
SUPERVISOR MODE
GENERAL FAULT
STATUS
ON
FLASHING
ON
FLASHING
ON
FLASHING
FLASHING
ON
ON
FLASHING
FLASHING
PAGE 4
ACTION
Fire detected alarms not sounded.
Fire detected alarms sounded.
No action. Alarm line delays are set
up.
Fire has been detected. Alarm delay
is in action, check for fire.
Refer to service provider (see front of
this manual for telephone number)
No action. Zone(s) disabled.
Zone in test. If service provider is on
site take no action. Else refer to
service provider (see front of this
manual for telephone number).
No action. Remote signal output is
isolated.
No action - you are in Supervisor
mode - see section on `Operating
The Panel`.
No action. System is self-checking.
Indicator should go out within 25
seconds.
Refer to Appendix B
Hide quick links:
Advertisement
Table of Contents
