Related Manuals for Humidex GVS-H
Summary of Contents for Humidex GVS-H
- Page 1 Nov 2015 Humidex GVS-H Rev. 2.1En Owner’s Manual Manufactured by: Clairitech Innovations Inc. 1095 Ohio Rd. Boudreau-West, NB Canada E4P 6N4...
-
Page 2: Table Of Contents
Table of Contents Table of Contents Service and Warranty OR CUSTOMER ASSISTANCE ONSUMER IMITED ARRANTY Before Installing ECHNICAL DATA ECOMMENDED TOOLS REQUIRED FOR INSTALLATION NCLUDED PARTS LIST DEAL INSTALLATION LOCATION ARNINGS FOR USE Installation How to Operate the Humidex Wiring Diagram... -
Page 3: Service And Warranty
Product name: Model #: Date of manufacturing: Serial #: Dealer name (if any): For the following inquiries: Service Parts Accessories Additional customer information Please contact us by: Phone: 1-888-533-1348 Email: support@humidex.ca Website: www.humidex.ca... -
Page 4: Consumer Limited Warranty
Consumer Limited Warranty Clairitech Innovations Inc. warrants to the first consumer that this Humidex product, when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective... - Page 5 Humidex The warranties described herein shall be the sole and exclusive warranties granted by Clairitech and shall be the sole and exclusive remedy available to the purchaser. Correction of defects, in the manner and for the period of time described herein, shall constitute...
-
Page 6: Before Installing
1pc. 4” vinyl flex Ideal installation location When looking for a location to install your new Humidex, make sure to place it on an outside wall so that the unit can exhaust its air outside. The unit should be installed near an electrical outlet and, if possible, in the dampest location. -
Page 7: Warnings For Use
Humidex Warnings for use The following warnings will help reduce the risk of fire, electric shock or injury. Please read and save these instructions. 1) Do not operate any unit with a damaged cord or plug. Please contact our service department for examination and/or repair. -
Page 8: Installation
Humidex Installation Please follow these instructions to install your Humidex properly. 1. From the inside, mark where the center of the Humidex will be placed and drill through the wall with a ¼’’x 12’’ pilot bit. hole should approximately 12 inches from the floor. Cut a 4 ½’’ hole through the wall. -
Page 9: How To Operate The Humidex
Humidity label Control knob After installing the decal and knob, plug the Humidex in the closest outlet. Set the dial to your humidity preference. If you wish to have the unit on for a continuous basis, turn the dial fully to the right (20%). -
Page 10: Wiring Diagram
Humidex Wiring Diagram...
Need help?
Do you have a question about the GVS-H and is the answer not in the manual?
Questions and answers