Table of Contents
Advertisement
Freezer feature
Ice maker operation
After freezer section reaches normal temperature, ice maker fills with water
and begins forming ice. Allow 24 hours to produce the first batch of ice. Ice
maker should then produce 7 to 9 batches of ice in a 24-hour period under
normal conditions.* Discard the first three batches of ice. After ice is formed,
ice cubes drop into storage bin. When ice bin is full, ice maker arm raises to
the "OFF" position (arm up). If ice is not needed, you can stop ice maker by
raising arm to "OFF" position (arm up). Listen for a click sound to be sure that
ice maker will not continue to operate. To start ice maker, lower arm to the
"ON" position (arm down). Do not force arm up or down. Do not store anything
on top of ice maker or in ice bin.
If ice maker is not producing ice, check that:
• arm is in "ON" position (arm down).
• water supply line shutoff valve is in "ON" position.
• wiring harness is completely inserted into receptacle in rear freezer wall.
• electrical connections to water valve coil are secure.
• copper tubing is not kinked.
• freezer is operating at proper temperature.
If ice maker is not producing enough ice, check:
• that all steps above have been checked.
• number of batches. Ice maker will make 7 to 9 batches in a 24-hour period.
For higher production, turn freezer temperature lower.
If ice maker makes unusual sounds, check:
• the "Understanding the sounds you may hear" section. The sounds may be
normal.
Full-width wire shelf
To remove wire shelf:
1. Tilt up front of shelf and lift it at the back.
2. Pull shelf straight out.
To replace wire shelf:
1. Insert rear shelf hooks into slots in shelf supports.
2. Tilt front of shelf up until rear hooks drop into slots.
3. Lower front of shelf. Check that shelf is securely in position.
Removable wire freezer rack
To remove wire freezer rack:
1. Slide wire freezer rack to the right until it releases from freezer shelf.
To replace wire freezer rack:
1. Align freezer rack between two shelf wires.
2. Push rack up and to the left until it snaps in place.
Removing the door shelves
To remove shelves:
1. Remove all items from shelf.
2. Grasp shelf at both ends.
3. Lift and pull out.
To replace shelves:
1. Insert shelf hooks into the guides on both sides of the door liner.
2. Pull down to lock into place.
16
S
Wire arm
Off
Off
On
On
Advertisement
Table of Contents
