Table of Contents
Advertisement
II_Installation
2. Software installation
Insert the MagicView UVC-500AF Set-up CD.
Do not connect the MagicView UVC-500 to the PC before driver and program are
installed. Otherwise, there may be no image coming to the PC monitor. If that happens,
close the MagicView UVC program being run, disconnect and then reconnect the USB
cable to the PC, and run the MagicView UVC program again.
(1) Install the main program
① Click "MagicView UVC-500AF Setup."
MagicView UVC-500AF Setup
MJPEG Codec Setup
③ Read the consumer license and accept
it by clicking "I Agree."
User Guide
Exit
② Installation starts. Click "Next."
④ Choose a folder to install the software
in an "Install" to continue the installation.
MagicView UVC-500 v1.03
7
Advertisement
Table of Contents
