Table of Contents
Advertisement
II_Installation
3. Hardware installation
(1) After installing the MagicView UVC-500 driver and viewer program, connect the USB
cable of the Document Camera to the USB port at the front or the rear of your PC.
Note
MagicView UVC-500 document camera can only be
used in USB 2.0 mode. Check if the PC supports
USB 2.0
(2) There is no need to install any special drivers to use MagicView UVC-500. After connecting
the USB cable of MagicView UVC-500 to a PC's USB port, wait a few seconds, a message
appears as "Your device is ready to use."
User Guide
PC의 후면에
USB ports at the
설치되어 있는
rear of the PC
USB 단자
MagicView UVC-500 v1.03
10
Advertisement
Table of Contents
