Table of Contents
Advertisement
5.5 Power-off Control Circuit
S1F76540 provides the power-off function, which turns each function on and off by issuing the signals shown in
Table 5.3 from the external system (microprocessor, etc.) to the POFF1X and POFF2X pins.
Using the power-off function, reactive current can be reduced in the application circuit connected in parallel.
When using the power-off function only in two states (all ON and all OFF), connect the POFF2X pin to VI;
power-on and -off can be controlled using only one POFF1X pin.
POFF1X
Mode name
(H=V
)
DD
(L=V
)
IN
PS1
H
PS2
L
PS3
H
PS4
L
(Note 1)
When the booster is off, the voltage of approximately VI+0.6V is generated in the VO pin.
(Note 2)
When the regulator is off, the V
[Notes on using the power-off function]
Before starting the power-off function with an external system signal, check that VI has been stabilized after
power-on. Turning the power on or off before the power is not stabilized will result in a permanent destruction
of this IC.
VI
POFF1X
POFF2X
S1F76540M0C Series Technical Manual
(Rev.1.1)
Table 5.3 Combination of power-on and -off modes
POFF2X
(H=V
)
Oscillation
DD
(L=V
)
circuit
IN
L
ON
L
OFF
H
OFF
H
ON
pin is placed into the high impedance state.
REG
Figure 5.4 Power-off control start timing
5. FUNCTIONAL DESCRIPTION
Function state
Booster
Regulator
ON
ON
OFF
OFF
(Note 1)
(Note 2)
ON
ON
OFF
ON
(Note 2)
VI
POFF1X
POFF2X
EPSON
Use
All circuit ON state
All circuit OFF state
Slave side in parallel connection
(Booster + Regulator)
Master side in parallel connection
(Booster only)
9
Advertisement
Table of Contents
