Table of Contents
Advertisement
Listening Safely
Specifications
Transmitter
Carrier Frequency ...................................... 3 channels (910.5, 915, 919.5 MHz)
Power Source ........................................................................... 9V DC, 200 mA
Frequency Response ....................................................... 80Hz – 20 kHz (6 dB)
Receiver
S/N Ratio (@ –50dBm) ......................................................... > 70 dB (A weight)
Audio Distortion ....................................................................................... < 1 %
Max. Audio output ............................................................................... > 3 mW
Power requirement ............................... AAA Alkaline/Rechargeable battery x 4
Specifications are subject to change and improvement without notice. Actual
product may vary from the product images in this document.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Changes or modifications not expressly approved by Ignition L.P . may cause
interference and void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. ��peration is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
33-282 UG.indd 8
Set the headphone volume to the lowest setting before listening. After you begin
listening, adjust the volume to a comfortable level.
Do not listen at extremely high volume levels. Extended high-volume listening
can lead to permanent hearing loss.
If you connect the transmitter to an audio source headphone jack, set the
audio source's volume to the middle position. Then adjust VOLUME on the
headphones to the desired level.
Turn off the headphones before turning off the transmitter. This prevents you
hearing a loud click that may be generated when you turn off the transmitter.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
9/17/2009 10:04:16 AM
Advertisement
Table of Contents
