NETGEAR D3600 Installation Manual page 9


EX2700

EX6100

EX6200
The device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with IC multi-transmitter product procedures.
The following statement applies to these products:

A6210

D6000

D6010

D3600

D3610

D6200V2

EX6100

EX6200
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-
channel mobile satellite systems.
DFS warning:
NETGEAR DFS (Dynamic Frequency Selection) products that operate in the bands 5250- 5350 MHz, 5470-
5600MHz, and 5650-5725MHz:
The following statements apply to this product:

A6210

C6300XB3

HMNC100

R8000

STS7000

WAC120

WNDR3400v3
The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz to comply with
the EIRP (Equivalent Isotropically Raditaed Power) limit.
Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN
devices.
The following statement applies to this product:

WAC120
The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the EIRP (Equivalent
Isotropically Raditaed Power) limits specified for point-to-point and non point-to-point operation as appropriate.
SAR warning:
NETGEAR product is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and
had been tested in accordance with the measurement methods and procedures specified in IEEE 1528.

R6050

R7500

R8000

HMNC100

JR6150

R6050

R7500

R8000

STS7000

WAC120

WN2500RP

WN3000RPv3

WNDR3400v3

WNR1000v4

WNDR3400v3