Figure - Pyle PHMD1 Instruction Manual

 Wave the search coil properly, keep the angle between search coil and aluminum
stem is about 140°. Please note improper backwards installation (Figure.8)
 Place the detector on a wooden or plastic table. Let the search coil hang over the
edge exceeding the table edge more than 5 inches(15cm). (Fig.9)
 Please take off your watch, ring or other metal objects on your hand or arm. Keep
the detector away from the wall, floor and other metal objects.
 Be sure to keep the detector away from the light, TV, computer and mobile
telephone, which can cause electro-magnetic interference.
3. Turn on
Turn on the power supply.
4. Adjust balance.

Press and hold the "Red Button", and adjust the "TUNE" knob, let the meter
pointer point at "0" position, release the Red Button. The meter pointer should
maintain near the "0", now the balance has been adjusted. The detector is in the
most sensitive detection state. (Fig.10).

Figure.8

Figure.9
6