Trouble Shooting Guide - Pyle PHMD1 Instruction Manual

1) Before detection every time, you should press Red Button to adjust balance,
release the button when detecting, you should not press the Red Button while
detecting.
2) The volume should be adjusted so that you can hear the sound, not adjust it too
loud. Normal volume is most productive when trying to differentiate between
sounds.
3) In areas with heavy traffic, please don't wear earphone, in case an accident occurs.
4) Always obtain permission before searching any site.
5) Keep away from the region that may bury electrical line, cable line or pipeline, in
particular the pipes that are full of flammable gases and liquids.
6) Do no detect in the military area that may be bombs or gas explosives.
7) When digging out the target, use a reasonable method, do not destroy the
vegetation. Leave the land and vegetation as it was after excavation.
8) When using earphone, don't set it too loud, this may damage your hearing.

Trouble Shooting Guide

SYMPTOM
No power
The unit is silent when turns on, and the
meter pointer doesn't move, it seems
there is no electricity.
Sound an irregular tone.
PARTS LIST
Part Description
1 PCB
1.Be sure that the polarity of batteries are
installed correctly.
2.Replace the batteries.
The balance has a deviation. Press the
Red Button, and adjust the TUNE knob to
let the detector be in balance state.
1.Make sure there is no other metal
detector operating around.
2.Don't use it indoors, because there are
many metals there.
3.Make sure whether there are no
electromagnetic
such as power lines, cables, electronic
fences and so on. Keep away from these
areas.
4.The ground may be magnetized due to
soil composition present.
Q'ty Part
1 20 Left Arm Rest Support
12
SOLUTION
interference sources,
PARTS LIST
Description Q'ty
1