Advertisement
Technical specifications
Power output
Headphone connection
THO
(IMD)
Gain
Signal to noise
Frequency response
Headphone jack
Outboard power supply
Power consumption
Dimensions
rtJ
x H x D)
Weight without power supply
PRO-JEeT HEAD BOX II
330mW/300hms,60mW/300ohms
Min.300hms
0,005% (0,001%)
11 dB
87dB ref. full output
30Hz - 20kHz/-O,05dB (10Hz - 120kHz/.1 dB)
3-pole
'/4.
(6,3mm 0) phono jack
16V12oomA AC, suitable for your country's mains supply
16V/120mA AC
103
x
38 x 127mm
600g
Potential incorrect use and fault conditions
No signal on one or both channels:
No connection between headphone and Head Box ore amplifier. This could be due
to a faulty plug, broken wire or solder joint or simply loose plug/socket connection.
Headphone does not work:
Headphone volume control is at minimum.
Amplifier Tope-Monitor circuit is not activated.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further odvice. Only when the problem cannot
be
resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
~
The
manufacturer accepts no
responsibility
for damage
caused
by not
adhering
to
these instructions
\\::0
for
use.
Modification or
change
to
any
part of
the produd
by
unauthorized
persons
release the
manufar;turer from any
liability over and above the lawful rights
of
the
customer.
PRO-JECT is a Registered Trademark of H. lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
©
2005.
All
rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
©
Audio Trade GmbH' Pro-Jed Head Box II . Revision 6.3.06/1.5.06
3
Advertisement
