Sfp Transceiver Installation; Copper Cable/Fiber Cable Connection - DCN DCS-3950-10C Installation Manual

DCS-3950 series Installation manual
The connection procedure is listed below:
1. Find the console cable provided in the accessory kit. Attach the RJ45 end to console
port of the switch.
2. Connect the other side of the console cable to a character terminal (PC).
3. Power on the switch and the character terminal. Configure the switch through the
character terminal.

2.3.4 SFP Transceiver Installation

DCS-3950 series provide multiple 1000Mb SFP transceiver slots.
The procedure for installing the SFP transceiver is shown below:
Step 1: Put on a ESD wrist strap (or antistatic gloves)
Step 2: Insert the SFP transceiver to the guide rail inside the fiber interface line card.
Do not put the SFP transceiver up-side-down.
Step 3: Push the SFP transceiver along the guide rail gently until you feel the
transceiver snap into place at the bottom of the line card.
Note: The SFP transceiver is hot swappable.
Caution!
Do not stare directly at the 2 fiber bore in the SFP transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.

2.3.5 Copper Cable/Fiber Cable Connection

Copper cables should be connected as below:
Fig 2-3 Connecting Console to switch
2-8
Chapter 2 Hardware Installation