Power Supply; Preventing Electrostatic Discharge Damage - DCN DCS-3950-10C Installation Manual

DCS-3950 series Installation manual

2.1.1.3 Power Supply

It is adopted module switch power for the switch, the input parameters of power are
shown below:
The AC input voltage: 100~240VAC
The frequency: DCS-3950-26C: 47Hz ～ 63Hz
The DC input voltage: DCS-3950-10C-R/DCS-3950-28C-R: 12V/2.5A
Before powering on the power supply, please check the input power to ensure proper
grounding of the power supply system. The input power for the switch should be reliable
and secure; a voltage adaptor can be used if necessary. The building's circuit protection
system should include in the circuit a fuse or circuit-breaker of no greater than 240 V, 10 A.
It is recommended to use a UPS for more reliable power supplying. .
Caution!
Improper power supply system grounding, extreme fluctuation of the input source,
and transients (or spikes) can result in larger error rate, or even hardware damage!

2.1.1.4 Preventing Electrostatic Discharge Damage

Static electric can cause damage to internal circuits, even the entire switch. Follow
these guidelines for avoiding ESD damage:

Ensure proper earth grounding of the device;

Perform regular cleaning to reduce dust;

Maintain proper temperature and humidity;

Always wear an ESD wrist strap and antistatic uniform when in contact with circuit
boards.
2.1.1.5 Anti-interference
All sources of interference, whether from the device/system itself or the outside
environment, will affect operations in various ways, such as capacitive coupling, inductive
coupling, electromagnetic radiation, common impedance (including the grounding system)
and cables/lines (power cables, signal lines, and output lines). The following should be
noted:

Precautions should be taken to prevent power source interruptions;

Provide the system with a dedicated grounding, rather than sharing the grounding
DCS-3950-10C series: 50Hz ～ 60Hz
DCS-3950-28C series: 50Hz ～ 60Hz
DCS-3950-10C-DC/DCS-3950-28C-DC: -40V ～ -48V/0.5A
Chapter 2 Hardware Installation
2-3