Logitech IO2 User Manual page 11

™
Logitech® io Digital Pen with Bluetooth®
2
Customized Passkey
The Bluetooth Passkey can be customized using the Bluetooth Digital Pen Configuration Utility, available from
Logitech. See Customizing Digital Pen Settings for more information.
Pen State
Cap Off
Discoverable
Pairing
Pairing
Succeeded
Pairing Failed
Connecting
Connection Failed
Sending
Sent OK
Sending Failed
Note If a Bluetooth transmission is active and the cap has been put on, the digital pen will finish the transmission
before turning off, and it will continue to give indicator feedback.
If a Bluetooth transmission is active and the digital pen is docked in the cradle, the pen will finish the
transmission prior to setting itself to communicate with the Bluetooth Digital Pen Configuration Utility
software.
If a Bluetooth transmission is active and the pen is being used to write, the pen will buzz to indicate that it
is busy until the transmission is finished. It cannot record new strokes until the transmission is complete.
Digital Pen States
Memory Indicator
Color Intensity Blink
Blue High Pulse every
2 secs.
Blue High Slow
triangle
wave
Green High Solid for
2 secs.
Red High Two pulses
then solid
for 2 secs.
Blue High Slow
triangle
wave
Red High Two pulses
then solid
for 2 secs.
Blue High Fast
triangle
wave
Blue High Solid for
2 secs.
Red High Two pulses
then solid
for 2 secs.
Vibrating Description
System
Timeout two minutes, pen down, cap on,
or USB connected.
Tick on pairing pidget; it indicates that the
digital pen is searching for a device to pair
with. Timeout two minutes, or pairing
succeeded/failed
Triple click Shows when pairing has succeeded, then
goes into standby.
1 sec. on No Bluetooth devices or problem with
Bluetooth pin code, or similar.
After the two pulses, the red light is solid to
finish the timeout, then goes to standby.
Connecting to a Bluetooth device.
Timeout depends on the type of the
connection with the remote device.
1 sec. on No Bluetooth devices, or similar.
After the two pulses, the red light is solid to
finish the timeout, then goes into standby.
Sending data to a Bluetooth device.
Triple click Shows when sending has succeeded, then
goes into standby.
1 sec. on No Bluetooth devices, or similar.
After the two pulses, the red light is solid to
finish the timeout, then goes into standby.
Page - 8