Table of Contents
Advertisement
1.
CONNECTING YOUR TV-VIDEO COMBI
Important for the United Kingdom
This machine is fitted with an approved moulded 13 Amp plug.
To change a fuse in this type of plug, please follow these
instructions.
a
Take off the fuse cover and take out the fuse.
b
Put in a new fuse which should be a BS1362 5A, A.S.T.A.
or BSI approved type.
c
Refit the fuse cover.
If the plug fitted is not suitable for your socket, cut it off and fit
another type.
If the plug you fit contains a fuse, it should be a 5Amp fuse. If
you fit a plug which does not need a fuse, make sure the fuse
on your fuse box is not greater than 5 Amps.
D Note: Please destroy the plug you have cut off so that it
cannot be used in a 13 Amp socket somewhere else.
How to connect a plug
The wires in the lead from the video recorder are coloured as
follows.
* Blue - 'neutral' ('N').
* Brown - 'live' ('L').
d
Connect the blue wire to the terminal in the plug which is
marked with the letter 'N' or coloured black.
e
Connect the brown wire to the terminal in the plug which
is marked with the letter 'L' or coloured red.
f
Do not connect either of the wires to the terminal in the
plug which is marked with the letter 'E', the symbol
coloured green or green and yellow.
Before you refit the plug cover, make sure that the grip at the
bottom of the plug is clamped over the plastic cover of the
lead, not just over the two wires.
4
Connecting the cables
a
Insert the aerial plug into the
b
Insert the plug of the mains cable into the wall socket.
c
If the little red light at the front of the set is not alight,
please switch on the set. The power switch
located on the left side panel of the set.
Connecting a decoder or other equipment
You can also connect additional equipment, for instance, a
decoder, a satellite receiver or camcorder to the
socket or a satellite receiver, camcorder to the
E If you don't connect a decoder, use the
connecting other equipment.
\
or
2
socket.
8
is
EXT.1
socket.
EXT.2
socket for
EXT.1
Advertisement
Table of Contents
