Advertisement
Advertisement
Table of Contents
Related Manuals for LG G5
Summary of Contents for LG G5
- Page 1 LG G5 REPAIR GUIDE Version 1 2016 Edition...
- Page 2 LG G5 REPAIR GUIDE LCD AND DIGITIZER REPLACEMENT RiAna Soto Repair Training Specialist rsoto@cellairis.com...
- Page 3 FOR EVERY REPAIR MAKE SURE TO COMPLETE, INITIAL, AND HAVE CUSTOMER SIGN THE CELLAIRIS REPAIR LIABILITY WAIVER FORM...
- Page 4 PRE-REPAIR DEVICE CHECK-IN...
- Page 5 TOOLS NEEDED • Philips screwdriver • Spudger • Tweezers • Isesamo • Pentalobe screwdriver • Magnetic Mat • LG G5 Digitizer/LCD...
- Page 6 HEAT-GUN PRECAUTIONS Always operate the heat gun on the lowest setting. • Keep face, hands, hair, and clothing away from the air stream. • The air nozzle also becomes extremely hot. Never grab the heat gun by the nozzle. • Never operate the heat gun by laying it on its side on a table.
- Page 7 ADDITIONAL PRECAUTIONS Magnetic Pad: During the repair, you will be utilizing a magnetic pad to organize the plethora of • differing screws that you will be pulling out of the iPhone 6S. Below is a list of several internal components of the iPhone 6S that should never be placed on the pad, or you risk damaging the hardware or erasing client data: LCD/Digitizer Assembly •...
- Page 8 ADDITIONAL PRECAUTIONS Power on/off: To avoid any damage to the hardware during the repair, it is best to have the device • powered off until you can get to and disconnect the battery. Battery: Never unplug any flex cables unless the battery has been completely disconnected to avoid •...
- Page 9 Tools: Pentalobe screwdriver STEP 1 Disassemble the device • Remove the battery by holding battery release button (located on the bottom left side of the device) and pull the bottom of device from the phone. This will expose the battery.
- Page 10 Tools: Isesamo STEP 2 • Next, remove the sim card by using sim card remover. The sim card is located on the right side of the device. • Remove the two (2) Philips screws located on the bottom portion of the phone exposed after removing the battery.
- Page 11 Tools: Philips screwdriver, STEP 3 spudger • Once those two screws are removed we can now lift open the glass display from the metal frame. This will require you to slide the pry tool all the way around the frame and flex up and in to separate. •...
- Page 12 Tools: Spudger, fingers • The display should be STEP 4 separated at this point. • Then begin disconnecting all cables holding down the motherboard. • The lcd flex cable can be disconnected. • Followed by unscrewing and removing the six (6) Philips screws.
- Page 13 Tools: spudger STEP 5 • After releasing all components attached to the motherboard you will be able to pull the motherboard off of the frame. • Put motherboard to the side in a safe area. • Use flat end of spudger to remove back camera.
- Page 14 Tools: Philips screwdriver, • spudger Next, use your pry tool to lift the STEP 6 screen off the frame so you will be able to put replacement part on the frame. • Slide the pry tool in between plastic black frame and the glass. Try to get underneath the lcd as well.
- Page 15 • spudger Next, you will want to remove the STEP 6 ear speaker. New full assembly G5 parts come with the housing and lcd all together. Because of that the only the camera and ear speaker will need to be transferred over to...
- Page 16 Tools: Philips screwdriver, spudger STEP 1 Reassemble of device • Assuming you are using the full assembly part you will have to transfer a few components over to new part. • First, transfer over the camera and ear speaker.
- Page 17 • Tools: Philips screwdriver, The components are transferred over so it is now time for spudger STEP 2 reassembly. • Reassemble of Device Place the motherboard into the replacement part frame. After that is in place reconnect the flex cables. •...
- Page 18 Tools: Pentalobe screwdriver STEP 3 Reassemble the device • Do Post test actions.
-
Page 19: Troubleshooting
STEP 4 Troubleshooting • If you notice the charger won’t snap all the way into the connector most likely the charging port isn’t all the way in. This will result in you opening the phone back up and adjusting the port push all the way in. •... - Page 20 C O N T A C T Riana Soto REPAIR 678.513.4020 x400 TRAINING rsoto@cellairis.com...