Troubleshooting; Soft Reset; Reset Pairing; Reset To Factory Settings - scala rider Rider Freecom 1 Manual

6. TROUBLESHOOTING

6.1 SOFT RESET

If your FREECOM 1 stops responding, reset it by either:
Turning it off and then on again (see
●
Using the supplied USB cable, connect your computer or wall charger to the FREECOM 1 USB port for 30
●
seconds.

6.2 RESET PAIRING

This option deletes all paired devices.
To reset pairing:
Press and
●

6.3 RESET TO FACTORY SETTINGS

This option deletes all paired devices and all configuration settings.
To perform a factory reset through the unit, do one of the following:
To use the unit buttons:
●
a. Check that your FREECOM 1 is in Standby (see
b. Simultaneously press
To use the SmartSet app:
●
a. Check that your FREECOM 1 is in Standby (see
b. Open the SmartSet app and tap
c. Tap Settings.
d. Tap Reset to Factory.

6.4 FAQ

Additional answers to common problems can be found at www.cardosystems.com/faqs.
Switching Your Unit On/Off
for 5 seconds.
+ + for 5 seconds
.
on page 6).
FREECOM 1 Modes and Events - LED Indications
FREECOM 1 Modes and Events - LED Indications
18
on page 21).
on page 21).