Makita EB5300TH Instruction Manual page 12

For tube throttle model: Set the stop control lever to
"I" position.
1
► 1. Stop control lever
For hip throttle model: Set the stop switch to "I" posi-
tion. And make sure that the throttle lever is set to low
speed position.
► 1. Stop switch 2. Throttle lever
3. Continue to push the primer pump until fuel comes
into the primer pump.
1
2
► 1. Choke lever 2. Primer pump
NOTE: In general, fuel comes into the carburetor by
7 to 10 pushes.
NOTE: Even the primer pump is pushed excessively,
an excess of gasoline returns to the fuel tank.
4. Lift the choke lever to the closed position.
5. Put your left hand on the top of the blower and pull
the starter handle slowly with your right hand until you feel
the compression. Then pull the starter handle strongly.
2
1
12 ENGLISH
NOTICE:
Never pull the rope to the full
extension.
NOTICE:
Return the starter knob gently into the
housing. Otherwise released starter knob may hit
your body or it may not rewind appropriately.
NOTE: If the engine fires and stops, return the
choke lever to the "OPEN" position and pull the
starter handle several times to start the engine
again.
6. When the engine starts, down the choke lever to
open position.
NOTE: Open the choke lever fully before pulling the
throttle.
NOTE: In cold temperature or when the engine is not
warm enough, never open the choke lever suddenly.
Otherwise, the engine may stop.
7. Warm-up for 2 to 3 minutes with engine speed idle
or low.
8. Warm-up is complete when quick engine accelera-
tion from low rpm to full throttle is felt.
NOTE: If the operator keeps pulling the starter
handle several times with the choke lever left in
the "CLOSE" position, the engine may be difficult
to start because of flooding of the fuel. In case of
flooding of the fuel, remove the spark plug and pull
the handle several times rapidly to discharge any
excess fuel. Dry the spark plug electrode.