PROFILO PSI3630 User Manual page 11

Problem
The clothes tend to stick.
Water comes out together
with steam.
Steam does not come out.
Spray does not work.
Water comes out from
the soleplate before
connecting the iron.
Smoke comes out when
connecting the iron for the
first time.
If the above does not solve the problem, get in touch with authorized technical service.
Disposal
Dispose of packaging in an environmentally-
friendly manner. This appliance is labelled in
accordance with European Directive 2012/19/
EU concerning used electrical and electronic
appliances (waste electrical and electronic
equipment – WEEE). The guideline determines
the framework for the return and recycling of used appliances
as applicable throughout the EU. Please ask your specialist
retailer about current disposal facilities.
The manufacturer does not accept any liability for any damages
resulting from unintended use or improper handling.
The manufacturer reserves his rights to modify the product any time
in order to adjust it to law regulations, norms, directives, or due
to construction, trade, aesthetic or other reasons, without notifying
in advance.
PSI3630-001_v01
Probable cause
1. Very high temperature.
1. Temperature regulator in very low
position.
2. Steam regulator in very high position
with low temperature.
1. Steam regulator in closed position.
2. No water in the tank.
3. Obstructed mechanism.
4. The temperature is too low. Anti-drip
system activated.
1. No water in the tank.
2. Obstructed mechanism.
1. The steam regulator is not properly
closed.
1. Lubrication of some of the inner
parts.
Solution
1. Turn the temperature dial to a lower
temperature.
1. Turn the temperature dial regulator to a higher
position and wait until the pilot light switches off.
2. Turn the steam regulator to a lower position.
1. Turn the steam regulator to an open steam
position.
2. Fill the tank.
3. Remove the needle and clean it, if this does not
help, contact the Technical Service.
4. Set a higher temperature if compatible with the
fabric.
1. Fill the tank.
2. Contact the Technical Service.
1. Make sure to place the steam regulator in
position "0".
Do not forget to empty the tank when you have
finished ironing.
1. Do not worry. It will disappear in a short period
of time, after the first usage.
11