Related Manuals for Refine WatchDog 900C
Summary of Contents for Refine WatchDog 900C
- Page 1 WatchDog 900C Installation and Operations Manual P:910-515-3033 E-mail:sales@refine-tec.com Add:Surf City,North Carolina USA...
-
Page 2: Table Of Contents
Table of Contents Warranty Registration Safety Notes Identification Electrical Supply Principle of Operation Installation Key Functions Indicator Lights Remote Control Operating Instructions Diagram Maintenance Dehumidifier Storage Ducted Applications Troubleshooting Spare Parts Warranty Information... -
Page 3: Warranty Registration
Warranty Registration Congratulations on purchasing a new Watchdog Dehumidifier. Your new dehumidifier comes with an extensive warranty plan. To register, simply fill out and return the warranty form provided in your dehumidifier box. Be sure to note your dehumidifier serial number as you will need it for registration. Safety Notes... -
Page 4: Identification
For future reference, write down the model, serial number, and date of purchase for your dehumidifier.This is extremely helpful if you need to seek assistance in the future. The data label on the side of your unit has the key characteristics of your specific unit. Model Number: Watchdog 900C Serial Number: Date of Purchase... -
Page 5: Key Functions
36%. 4. Central Control • This mode is not applicable on the WatchDog 900c. 5. Manual Drain Button • For extended storage or movement of the machine, press the “Drain” button to remove water from... -
Page 6: Indicator Lights
6. Pump Trouble Warning When the pump reservoir water level is too high, the high water sensor will activate to prevent over-flow. When this occurs, the dehumidifier will stop the compressor automatically and the display willshow “E4”. After a 1 minute delay, the fan motor will turn off and the machine will not operate until the problem is resolved. -
Page 7: Remote Control
Remote Control Instructions Watchdog Dehumidifiers can be controlled using an optional remote accessory.The Watchdog Remote Control connects to your Watchdog Series Dehumidifier via a 25’ CAT 5 cable. The remote control contains an integrated sensor which gives you multiple options for remotely controlling your unit, in addition to monitoring the conditions surrounding the dehumidifier. -
Page 8: Diagram
NOTE: Do not disconnect power cord to forcemachine to stop. Always use power button. 4. Water Drainage The Watchdog 900C has both automatic and manual draining. During normal operation, the Watchdog 900C will automatically drain as required. If you would like to store or move the machine, you may press the drain button to drain the water from the pump reservoir. -
Page 9: Maintenance
WARNING: Condensate Pump Your Watchdog 900C is equipped with an integral condensate pump designed to pump water from your dehumidifier out to the desired drain. This pump requires routine maintenance that is not covered by your 1 year parts warranty. Only a defective pump will be repaired or replaced during the warranty period. -
Page 10: Dehumidifier Storage
Cleaning/Disinfecting the Pump Basic Cleaning (Complete about once a year, depending on environment) 1. Remove the end cap on the filter side of the unit. Press the drain button to drain the resevoir. 3. Mix a 16 oz solution of either (1 oz bleach + 15 oz water) OR (4 oz white vinegar + 12 oz water). 4. - Page 11 Be sure to secure the ducting with tie wrap. Also, keep in mind, that the supply ducting can be screwed into an adapter if necessary. Ducting Installation 1. Remove inlet grille from end cap 2. Connect duct to inlet grille 3.
-
Page 12: Troubleshooting
Pump Alarm- Trouble Code E2/ E4 If a pump alarm is shown on the display, complete the following steps: 1. Reset the unit by disconnecting the power cord and then reconnecting it. NOTE: UNIT WILL NOT FUNCTION UNTIL ERROR CODE HAS BEEN CLEARED. 2. -
Page 13: Spare Parts
Watchdog 900c Spare Parts Remote Control Remote Control Internal Components Internal Components W-908 Compressor Remote Control W-100 Assembly (Includes W-909 Compressor Capacitor W-101 and W-102) Temp/RH Sensor W-910 Cable W-101 Watchdog Remote Control W-911 Display Ribbon Cable Watchdog Remote Coil Temp Sensor... -
Page 14: Warranty Information
1. Customer must mail in warranty registration card (on page 13) to Refine. If no card is submitted, warranty period will begin the day the shipment left the Refine warehouse. Please be sure to record serial # and date of installation in the spaces provided on page 2 of the manual. - Page 15 REMEDY FOR ANY BREACH OR ALLEGED BREACH OF WARRANTY BY SELLER. ANY DISHONESTY OR FRAUD IN CONNECTION WITH REFINE WARRANTY THOROUGHLY VOIDS ALL WARRANTY POLICIES. REFINE EXPRESSLY RESERVES THE RIGHT TO PURSUE LEGAL ACTION IN THE EVENT OF DISHONESTY, FRAUD, OR ATTEMPTED FRAUD.