Techne TE-10A Operator's Manual page 4

The fuse in the unit protects the unit and the operator
Note that units marked 230V on the rating plate work at 220V; units marked 120V work at 110V. In
both cases, however, the heating rate will degrade by approximately 8%.
3. Plug the mains cable into the socket on the rear of the unit.
4. Do not switch on until the unit is fully installed, see page 19.
5. Note that the following symbols may be next to the indicator lamps on the front panel of the units
and have the following meanings:
the power indicator
the heater indicator
the over-temperature indicator
6. Symbols on or near the power switch of the unit have the following meanings:
I mains switch On
O mains switch Off
WOrkIng EnvIrOnMEnT (all units)
The Thermoregulator units are designed to work safely under the following conditions:
Ambient temperature range 5°C to 40°C
Humidity - up to 95% relative humidity, non-condensing
note: The control specifications quoted are for an ambient temperature range of 10°C to 30°C.
The specification may deteriorate outside this range but the unit will still work safely.
Radio frequency interference tested and passed to EN50081-1.
Immunity Tested and passed to EN50082-1
gUArAnTEE
The unit is guaranteed against any defect in material or workmanship for the period specified on the
enclosed guarantee card. This period is from the date of purchase, and within this period all defective
parts will be replaced free of charge provided that the defect is not the result of misuse, accident or
negligence. Servicing under this guarantee should be obtained from the supplier.
Notwithstanding the description and specification(s) of the units contained in the operator's manual,
Techne hereby reserves the right to make such changes as it sees fit to the units or to any component of
the units.
This manual has been prepared solely for the convenience of Techne customers and nothing in this
instruction book shall be taken as a warranty, condition or representation concerning the description,
merchantability, fitness for purpose or otherwise of the units or components.
4