Techne TE-10A Operator's Manual page 3

Thermoregulator
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Please read all the information in this booklet before using the unit.
WArnIng
HIGH TEMPERATURES ARE DANGEROUS: they can cause serious burns to operators and ignite
combustible material.
Techne have taken great care in the design of these units to protect operators from hazards, but
operators should pay attention to the following points:
• USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS;
• DO NOT put hot objects on or near combustible objects;
• DO NOT operate the unit close to inflammable liquids or gases;
• At all times USE COMMON SENSE.
OpErATOr sAfETY
All operators of Techne equipment must have available the relevant literature needed to ensure their
safety. It is important that only suitably trained personnel operate this equipment, in accordance with the
instructions contained in this manual and with general safety standards and procedures. If the equipment
is used in a manner not specified by Techne the protection provided by the equipment to the operator
may be impaired.
All Techne units have been designed to conform to international safety requirements and are fitted with
an over-temperature cut-out. On some models, the cut-out is adjustable and should be set to suit the
application. On all other models the cut-out is preset to protect the unit.
If a safety problem should be encountered, switch off at the mains socket and remove the plug from the
supply.
InsTAllATIOn
1. All Techne units are supplied with a power cable. This may be integral or plug-in.
2. Before connecting the mains supply, check the voltage against the rating plate. The rating plate is on
the rear of the unit. Connect the mains cable to a suitable plug according to the table below.
note that the unit must be earthed to ensure proper electrical safety.
Connections
Live
Neutral
Earth
The fused plug supplied with the mains lead for use in the UK is fitted with the following value fuse to
protect the cable: 5 AMP for TE-10A and TE-10D; 10AMP for the TU-20D.
sAfETY AnD InsTAllATIOn
220V-240V
110V-120V
Brown
Black
Blue
White
Green/yellow
Green
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Te-10dTu-20d

Table of Contents