Danfoss TP75-RF Installation & Commissioning Manual page 2

Fig. 2 TP75-RF or TS2 location
1. TP75-RF Select the desired fixing position. (This should adhere
to normal room thermostat practice, see Fig. 2).
2. When fixing the heating controller wallplate note that the terminals are
at the top and the vertical centre line of the heating controller is at the
right hand edge of the terminal 4 recess. Observe the clearance
required for fitting and removal, Fig. 3.
3. Fix the wallplate to the wall.
4. Before fixing the unit on to its wallplate, ensure that the four DIP
switches on the rear of the unit (see Fig. 4) have been moved to the
required settings; the choices are:-
5/2 day
OSC ON
Chrono 6
7 day
OSC OFF
ON/OFF
Chrono 3
Switch No. 1- 5/2 DAY or 7 DAY.
5. Position the slots in the top surface of the module over the lugs at the
top of the wallplate, and hinge downwards until the module is pressed
fully against the wallplate. Tighten the two screws from below to fix the
module to the wallplate.
6. Before setting the programmes the unit and circuits should be checked.
Refer to the following Commissioning Instructions.