Download Print this page

Magnacoustics Genesis ULTRA Installation Manual

Communications / mri music system

Advertisement

Communications / MRI Music System 
System Notes:
Headset Operation:
Technologist Control Unit Operation:
Important Safety Instructions:
Pre Installation:
System Parts List:
Genesis ULTRA Installation and Connections:
Rear Panel:
Component Locations and Wiring Flow:
Genesis ULTRA   
Installation Manual
Index
Magnacoustics Inc™ © 3/2008 rev-o
2
3
4, 5, and 6
7
8
9, 10
10, 11, and 12
13
14
1 |

Advertisement

loading
Need help?

Need help?

Do you have a question about the Genesis ULTRA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Magnacoustics Genesis ULTRA

  • Page 1 Headset Operation: Technologist Control Unit Operation: 4, 5, and 6 Important Safety Instructions: Pre Installation: System Parts List: 9, 10 Genesis ULTRA Installation and Connections: 10, 11, and 12 Rear Panel: Component Locations and Wiring Flow: Magnacoustics Inc™ © 3/2008 rev-o...
  • Page 2: System Notes

    System Notes Our Genesis ULTRA Music System has a number of new features that need to be fully understood to use this system to it’s full potential • Music provides comfort to the patient during the procedure • Our yoke style headsets attenuate gradient noise to patient’s ears by 26.7 dB •...
  • Page 3: Headset Operation

    Headset toward the rear of the patients’ head, then while applying pressure rotate fully forward to align with the ear canal as pictured above It is highly recommended that technologists experiment on themselves to get a feel for this operation. Magnacoustics Inc™ © 3/2008 rev-o...
  • Page 4 VOL- button) will raise Volume for the Patients. 10: The Genesis has a feature called AUTO GAIN this provides the ability to automatically adjust volume level of music to Patients dependent on the amount gradient noise being created by MRI. Magnacoustics Inc™ © 3/2008 rev-o...
  • Page 5 NORM 11. Ambient MIC Level 12. Scan MIC Level 13. Boot Mode Norm Diagnostic 14. FMRI Pulse High Pulse Low High Held Low Held 15. IR Remote 16. IR Remote Dwell 2Sec 3Sec 4Sec 1Sec Magnacoustics Inc™ © 3/2008 rev-o...
  • Page 6 Magnacoustics Inc™ © 3/2008 rev-o...
  • Page 7: Important Safety Instructions

    Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference. Magnacoustics Inc™ © 3/2008 rev-o...
  • Page 8: Pre-Installation

    Pre Installation Mean Time to Install Allow 3 man-hours for unpacking, installation, checking and setting up of Genesis ULTRA MRI Music System. Additional time may be required when difficult ducting of cables is encountered. Recommended service tools for installation: 1. Nut Driver set 2.
  • Page 9 23: Gradient noise sensing Mic (with 10 ft. cable for AGC.) 24: 5 Zip Ties and 5 mounting pads to dress cables. 25: Stereo remote control and 2 AA batteries. 26: Intercom Mic. 27: Genesis Module. Magnacoustics Inc™ © 3/2008 rev-o...
  • Page 10 Genesis ULTRA Installation and Connections Refer to Stereo Manual for Illustrations, and for identification of controls. CAUTION Ensure that AC cords from the Stereo and Genesis module are not connected to power source until all connections are completed. Also ensure that the power entry receptacle is set up for...
  • Page 11 Genesis ULTRA Installation and Connections continued A. For Horizon LX remove run 788 from J7 on the WIM Module and connect to the open connector on the AutoVoice Breakout Box, then connect the other end of “CB4” to J7 on the WIM.
  • Page 12 35: Look at the front panel of the Genesis and ensure the all-8 red LED’s are lit under Circuit A Power and Circuit B Power. If not pull AC Power and contact Magnacoustics Tech Support at 1- 800-637-2282 or E-mail at support@magnacoustics.com...
  • Page 13 Rear Panel Genesis ULTRA J1= Audio Input from Stereo Tech Unit Connector J2= fMRI Input RS232 Spare J3= Video Input J10= RS 232 Spare J4= MIC Input J11= To Transducer “CB1” J5= AVC Input J12= AC Receptacle 5 amp SB...
  • Page 14 Component Locations and Wiring Flow Pen Panel AutoVoice Breakout 14 | Magnacoustics Inc™ © 3/2008 rev-o...