Changing A Wiper Blade; Changing A Fuse - PEUGEOT 5008 2017 Handbook

In the event of a breakdown

Changing a wiper blade

Before removing a front
wiper
F Within one minute after switching off the
ignition, operate the wiper control stalk to
position the wiper blades in the middle of
the windscreen (maintenance position).
Removing
F Lift the corresponding wiper arm away from
the windscreen.
F Unclip and remove the wiper blade.
Refitting
F Position and clip the new wiper blade to the
arm.
F Carefully lower the wiper arm.
284
After refitting a front wiper
F Switch on the ignition.
F Operate the wiper control stalk again to
park the wiper blades.

Changing a fuse

Replacing a fuse
Before replacing a fuse:
F the cause of the failure must be identified
and rectified,
F all electrical consumers must be switched
off,
F the vehicle must be immobilised with the
ignition off,
F identify the defective fuse using the existing
allocation tables and diagrams.
To replace a fuse, you must:
F use the special tweezers to extract the fuse
from its housing and check the condition of
its filament.
F always replace the failed fuse with a fuse
of the same rating (same colour); using a
different rating could cause faults (risk of
fire).
If the fuse fails again soon after replacement,
have the vehicle's electrical system checked by
a PEUGEOT dealer or a qualified workshop.