Table of Contents
Advertisement
Philips Semiconductors
5.9.
Other Jumpers
5.9.1. J13 (NOOC)
This jumper will set the OC capabilities in the hub's descriptors (see Table 5-4).
Table 5-4: Overcurrent Support Selection Using J11 and J12
*—Default settings.
Note: this jumper is for setting the hub's descriptor only. To inhibit the overcurrent detection,
the OC pins must be tied to V
5.9.2. J14 (SUSPEND)
This jumper is provided for debugging purposes. Logic 1 on the SUSPEND signal indicates that
the hub is in the suspend mode. In the default setting jumper J14 is used (pulled down to GND).
Table 5-5: J14 Mode Setting
6. Schematics
User manual
J13
NOOC
OFF
No overcurrent support
ON
Overcurrent support*
CC
J14
OFF
ON
Rev. 04.00 — 17 June 2004
ISP1521 Hi-Speed USB Hub Demo Board
(5 V)
Mode
Debugging purpose
Normal mode (default)
UM10011_4
Logic State
1 (HIGH)
0 (LOW)
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
11 of 20
Advertisement
Table of Contents
