Table of Contents V.5.1 Content Diagram 100W 200W Mounting Instructions 100W 200W Wiring Diagram 100W 200W Wiring Explanation List of Tones Warning! Any Storm unit with the below label is not compatible with the 4200 Data link model. Do not connect the RJ45 port on this unit to a 4200 datalink unit F E NIE X .
Content Diagram: 100 V.5.1 Storm Pro 100W Siren System Specification: Input Voltage: 12V DC Temperature Range: -20°C to +50°C Max Current: Stand By Current: Less than 30mA Power Output: 100W Main Fuse: Feature 1: Horn Ring Feature 2: Park Kill Feature 3: Radio Rebroadcast Feature 4:...
Page 4
Content Diagram: 200 V.5.1 Storm Pro 200W Siren System Specification: Input Voltage: 12V DC Temperature Range: -20°C to +50°C Max Current: Stand By Current: Less than 30mA Power Output: 100W per Speaker, 200W Total Main Fuse: Feature 1: Horn Ring Feature 2: Park Kill Feature 3:...
Mounting Instructions: 100W V.5.1 Mounting Instructions: 1.) Place the unit against the intended mounting surface. 2.) Mark the areas where the mounting holes will be drilled. If the mounting surface is part of the vehicle, make sure no vital components could be damaged by the drilling process. 3.) Drill four 4mm mounting holes on the 1.9685”...
Page 6
Mounting Instructions: 200W V.5.1 Mounting Instructions: 1.) Place the unit against the intended mounting surface. 2.) Mark the areas where the mounting holes will be drilled. If the mounting surface is part of the vehicle, make sure no vital components could be damaged by the drilling process. 3.) Drill four 4mm 1.9685”...
Wiring Diagram: 100W V.5.1 Park Kill and Horn Ring will activate on a + signal from the BCM. Every vehicle's BCM is different in terms of its output signal. Tone select switch Data Link Port USB port not used Warning! Any Storm unit with the below 15 ft label is not compatible with the 4200 20 Amps...
Page 8
Wiring Diagram: 200W V.5.1 Park Kill and Horn Ring will activate on a + signal from the BCM. Every vehicle's BCM is different in terms of its output signal. Tone select switch Data Link port USB port not used 15 ft Warning! Any Storm unit with the Version 1 Storm 100W label (see page 7) is not compatible with the 4200 Data link...
Wiring Explanation V.5.1 Using Dual Delay Dual Delay can be used when both speakers play the same standard siren tone. When Dual Delay is activated, the tones start playing out of sync to create the delay effect. Dual Delay applies only for standard siren tones with Dual Delay capability. Dual Delay does not affect audio tones.
List of Tones V.5.1 List of Current Standard Tones Tone Frequency Range Wail 725-1500 Yelp 725-1600 Fast Yelp 725-1500 Phaser 650-1725 Horn 600 and 1200 Mechanical 770-1370 Manual Wail 725-1500 High/Low 550 and 750 P Call Slow 500-1075 P Call Fast 500-1075 Horn-Phaser See Horn and Phaser...