After Each Wash; Select Options And Change Settings/Display Panel; Overview Of Programmes - Bosch WAS32890EU Operating Instructions Manual

ng

After each wash

10.
9.
l dosage
ntelligent dosage :
gent
8.
or intelligent dosage :
Fascia
Serviceflap
Washing machine door
with handle
ng
Switch off
Set programme selector to Off.
Turn off tap
Not required for Aqua-Stop models.
separate Installation/Maintenance instructions,
Page 6
Remove the washing
Open washing machine door and remove washing.
– Remove any foreign objects –
risk of rusting.
– Leave detergent drawer and door open
so that residual water can evaporate.
End of programme ...
... when finished, Remove washing is indicated on the
display panel.
When the display panel light is off, select any
button. Energy saving mode, Page 1
Rinse hold
If Rinse hold active:
– select Empty and/or Start/Reload.
Terminating the programme
For programmes at high temperature:
– Cool down washing: select / Rinse/Spin.
– Select Start/Reload.
For programmes at low temperature:
– Select / Rinse/Spin * or Empty.
– Select Start/Reload.
* Spin only Page 10
Reloading washing ...
Page 9
... if Start/Reload selected and then Reload
possible is indicated on the display panel.
– Do not leave washing machine door open for
a prolonged period – water could run out of
the washing.
– Load display is not active during relosding.
Select Start/Reload.

Select options and change settings/Display panel

Press the / Options buttons to select the following standard settings and programme options.
The settings in the options can be adjusted/changed by pressing the
case of multi-level settings keep touching the
automatically.
The display panel provides information on: options and settings, programme sequence and
additional information ( separate Installation/Maintenance instructions, What to do if ..., Page 11).
Each setting is active without acknowledgement. Standard settings are underlined on the
display panel and are retained even after the appliance is switched off and on again.
Standard settings
i-DOS2: Softener –
detergent
content
10 ml – 200 ml
i-DOS1: basis
10 ml – 200 ml
i-DOS2: basis
OFF – quiet –
Signal
medium – loud –
very loud
OFF – quiet –
button signal
medium – loud –
very loud
language
VarioPerfect SpeedPerfect
Standard
EcoPerfect
stain selection
end time 1 – 24h
(h=Hour)
Rinse plus max. +3 Rinse
cycles
Easy-iron OFF – ON
Rinse hold OFF – ON
Water Plus OFF – ON
Prewash OFF – ON
5
/ Change buttons. In the
/ Change buttons to run through the settings
Programme options
Options
Select dispenser contents. Page 13
Set basic dosage, Page 12, according
to recommendation of the detergent/softener
manufacturer.
Select volume of the information signals.
Select volume of the button signals.
Select language for display text.
For a shorter wash time with a comparable
washing performance to the standard
programme. Maximum load size.
Overview of programmes, Page 7
For saving energy with a comparable washing
performance to the standard programme.
Automatic treatment of stubborn stains.
Page 10
When the programme is selected, the respective
time to programme end is shown. Adjustable
in1-hour steps up to max. 24 h. Settings cannot
be made when the programme has started.
Additional rinse. Longer programme duration.
Recommended application: for sensitive skin
or/and in areas with very soft water.
Special spin sequence with subsequent fluffing.
Gentle final spin at reduced spin speed. Residual
moisture of the washing slightly increased.
The washing remains in the water after the last
rinse cycle. Page 5
Increased water level. Gentler treatment of the
washing.
For heavily soiled washing. Follow dosage
instructions. Page 9
6