Advertisement
F. Room Storage
Note: If room is put away when conditions are wet, it
should be set up and allowed to dry as soon as possible
to prevent mold and mildew.
1. Loosen and unfasten buckle straps at rear top
corners of the X Tend A-Room
2. Unfasten hooks on the elastic cord and snap fas-
teners at bottom of room front corners.
3. Remove center roof pole assembly by un-clip-
ping the C-clip from arched front pole assembly.
Remove the Center pole support with ball socket
from rear/frame pole assembly. Disassemble
center pole and place in pole storage bag.
4. Carefully pull the ball ends out of the ball end
bases. Loosen the lock levers and shorten the
side poles to the shortest length and lock the
levers. The front fabric will start to collapse. Re-
move the five hook/loop straps from the arch and
the pole assembly is free and the fabric will fall
to the ramp. Disassemble front pole and place in
pole storage bag.
5. Loosen the lock levers and lower the rear/frame
pole assembly to its shortest height. Place levers
in the lock position. The entire X Tend A-Room
will be completely on the ramp. Loosen the locks
on the horizontal pole and collapse to the short-
est length. Remove vertical side pole from the
horizontal pole and slide it out of the sleeves on
the fabric. Repeat for other side. Do the same
with the horizontal pole and take apart the entire
rear/frame pole to be placed into the pole storage
bag. Tie the pole storage bag closed.
TO REDUCE THE RISK OF DEATH, PERSONAL INJURy, FIRE OR DAMAgE:
1. The stands support the X Tend A-Room
a total of 1,200 pounds including persons, equipment and ramp.
2. Do not use grills, hibachis, camp stove or gas burning lamps inside the X Tend A-Room-
.
TM
3. Never operate generators, motorcycles, any internal combustion engines inside the X Tend
A-Room
.
TM
4. Close attention is necessary when used by or near children. Do not allow children or adults
to lean against the sides or front of the X Tend A-Room
5. Do not suspend electrical lights from rafter poles or allow them to come in contact with
the X Tend A-Room
6. Do not modify or change the installation of this X Tend A-Room
7. Follow all trailer manufacturers instructions regarding ramp use and limitations.
8. Use only as described in this manual.
.
TM
TM
fabric.
TM
X TEND A-ROOM
INSTALLATION AND OPERATION SUPPLEMENT
TM
6. The room is folded by bringing the sides into the
middle. Fold the each side again to the middle
until the fabric is the width of the pole storage
bag.
Personal injury may result from falling or
stepping off the end of the cargo ramp when
the room is installed.
7. Roll the fabric assembly tightly around the poles
in the pole storage bag squeezing out the air. In-
sert the fabric and poles into the X Tend A-Room-
storage bag. Store in a dry place.
TM
8. Disassemble ramp stands in reverse of assembly
(see section "A" on page 3), and place in the stor-
age bag.
and ramp. The stands are designed to support
TM
.
TM
6
.
TM
Advertisement
