Advertisement
1. Extend all 3 pole assemblies to their longest
length.
a. Center Pole Assembly
The center pole assembly is made of 3 piec-
es and rest along the expansion zipper on the
center of the roof of the inside of the X Tend
A-Room TM and parallel with the zipper. The
pole has a "C" clip on one end and a J-sup-
port on opposite end. See Fig. 2.
FIg. 2
Center Pole Assembly
3A
Lock
Lever
Ball End
w/J-Support
b. Front pole assembly
The front pole contains 11 pieces. When as-
sembled, the horizontal poles will form an
arch between the vertical poles. The vertical
poles have a ball which is inserted into an
end ball base and attached to the ramp floor.
See Fig. 3.
Extend the vertical telescoping poles to their
longest length. Lock in place with the lock lever.
See Fig. 3.
c. Rear/Frame Pole Assembly
The rear/frame pole when assembled, will form
a square. The vertical poles will be capped on
the bottom end with rubber caps to prevent
slipping and will be placed on the trailer floor.
See Fig. 4.
D. X Tend A-Room
1. Spread the X Tend A-Room
ramp. The zippers should be on the inside and
the open end of the room towards the trailer
opening.
2. Locate the fabric sleeves on each side of the
open end on the rear of fabric assembly. Assem-
ble the vertical side poles 1C, 1D and 1E of the
rear pole assembly. Place the lock levers in the
down/locked position. Feed the vertical side pole
caps down through the two side panel sleeves,
starting at the top panel.
3. Assemble the horizontal poles (1A & 1B) of the
rear pole assembly. Place the lock levers in
the down position and slide them through the 4
sleeves across the roof panel of the fabric. See
Fig. 4.
4. Insert the horizontal pole assembly into the verti-
cal side poles to form the rear frame.
"C" Clip
3B
3C
Assembly
TM
fabric on the cargo
TM
X TEND A-ROOM
INSTALLATION AND OPERATION SUPPLEMENT
TM
FIg. 3
Front Pole Assembly
FIg. 4
Caps
Rear/Frame Pole Assembly
5. The fabric and rear pole assembly are moved in-
side the trailer door opening. Extend the horizon-
tal frame of the rear pole assembly equally until
they touch the trailer side walls. Place the levers
in the locked position.
Note: The width of the room can be increased by unzip-
ping the dart (extra fabric) in the center of the roof fabric.
6. Raise each vertical side pole until the horizontal
pole touches the trailer ceiling. Place the levers in
the locked position.
7. The rear pole assembly will hold the X Tend A-
Room
in place inside the trailer.
TM
4
2A
2B
2C
2D
2E
Lock
Levers
2F
Ball Ends
w/Bases
1A
1B
1C
1D
1E
Caps
Advertisement
