Hitachi CP-X2511N Service Manual page 51

CP-X2511N(C15I-25N2) / CP-X3011N(C15I-30N2) / CP-X4011N(C15I-40N2) / CP-X2011N(C15-20N2) / ED-X45N(C15-20N2)
When assembling
a. Tighten 8 screws on the bottom and 2 screws on the rear after attaching the upper case with the lamp
door separated.
In order not to make a gap between the upper and the bottom cases, tighten these screws while pressing
down the upper case in the direction of the arrow. Be careful not to bend the outside casing.(Torque:0.39-
0.59N•m)
2 screws
b. Attach the Lamp door.
This is not a screw hole. Do NOT insert a screw
or screwdriver into it to avoid damaging the in-
side.
Lamp door
CAUTION
Tighten this screw using a manual screwdriver.
51
CAUTION