Before Brewing Your First Pot; Programming Your Coffee Brewer; Setting The Clock - Cuisinart CPO-800C Instruction Booklet

BEFORE BREWING YOUR
FIRST POT OF COFFEE
RINSING YOUR COFFEE BREWER:
We recommend flushing out the system before
brewing your first pot of coffee. Simply fill the
reservoir, power on the unit, and follow steps 1,
3 and 5 on page 9 under MAKING COFFEE.
Do not add coffee!
Charcoal Water Filter
Your coffee brewer comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odours from tap water.
Inserting the Water Filter
• Remove the filter from polybag and soak it,
fully immersed, in cold tap water for
15 minutes.
• Lift the water filter holder out of the
water reservoir.
• Press down on the filter compartment
and pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running cold tap water
through holes in bottom of compartment
for 10 seconds.
• Allow the filter to drain completely.
• Slide the water filter holder back into the
channel in the water reservoir, pushing it
down to the base of the unit
NOTE: We recommend
changing the water filter every
60 days or after 60 uses, and
more often if you have hard
water.
Replacement filters can
be purchased in stores, or by
calling Cuisinart Customer
Service, or at
www.cuisinart.ca
.
8
PROGRAMMING YOUR
COFFEE BREWER

SETTING THE CLOCK

When the coffee brewer is plugged in, 12:00
will flash in the display for 30 seconds,
indicating the unit is in Clock Set mode.
If 12:00 stops flashing, simply press the menu
button 4 times to the clock option and the time
will return to flashing Clock
Set mode.
SETTING HOURS AND MINUTES
Use the up arrow
arrow to set minutes. Hold buttons down to
scroll through the digits quickly, or press and
release to advance one digit at a time. Be sure
the PM indicator is on if setting a PM time.
Once time is correct, press MENU to set, or five
seconds after finishing, the unit will
automatically exit Clock Setting mode.
AUTO ON FUNCTION
1. To set AUTO ON brew time:
Press and hold the Auto On button for
2 seconds. The digital display will flash the
default (12:00) or previously selected time
and the AUTO ON button will flash. Follow
directions under SETTING THE CLOCK
(above) to program your start-brew time.
Five seconds after finishing, the unit will
automatically exit Auto On Setup mode.
AUTO ON will appear on the control panel
and the AUTO ON button will illuminate
indicating AUTO ON is activated.
NOTE: To exit Auto On Setup mode, you
can also just press Auto On button again.
2. To reactivate Auto On feature:
To start at the same time on another day,
simply press the AUTO ON button. The time
will appear, release button and AUTO ON
will appear on control panel and AUTO ON
button will be illuminated.
3. To deactivate Auto On:
Press illuminated Auto On button; AUTO
ON will not be displayed on control panel
and AUTO ON button light will turn off.
to set hours and the down