Tools Required For Installation - Equalizer Systems Auto-Level Installation Manual

Equalizer Systems Auto-Level Installation Guide
This manual is intended to be used by technicians installing Equalizer Systems
Auto-Level systems. It is assumed that the reader is familiar with hydraulic,
mechanical, and electrical systems; in addition to workplace safety.

Tools Required for Installation


Ratchet, sockets and wrench set

Wire cutters / crimpers

Electric drill and bits

Screw gun bits

Welding equipment (if welding leg or bracket in place)
Additional Items Required for Installation

# 4 AWG power wire (to connect battery +12V positive to the pump)*

# 4 AWG ground wire (to connect battery -12V ground to pump)*

# 4 AWG ring terminals

Loom clips (to secure harnesses and hydraulic hoses to the coach)

Self tapping screws or pop rivets

Wire ties

10 - 16 quarts Dexron Automatic Transmission Fluid
* Note: These items must be # 2 AWG if cable run is greater than 12 ft.
Modification of any factory-supplied item may result in the denial of all warranty claims. Call
Equalizer Systems Technical Support prior to any modifications.
With any hydraulic application, holding position on a cylinder must be done with safety in mind.
Failure in the system may cause the jack(s) to retract or extend suddenly. When working under or
near the coach, always use jack stands of appropriate rating to support the weight of the coach.
2