C Board Removal; Prism Block (G) Assy And Out-Polarization Assy Removal - Sony VPL-FX52 Service Manual

1-2-6. C Board Removal

1 Three screws
(+PSW 3x8)
CN5701
CN3009 (board to board)
CN3010 (board to board)

1-2-7. Prism Block (G) Assy and Out-polarization Assy Removal

* To remove the prism block (G) assy and Out-polarization assy, remove the C board beforehand.
1Four screws
(+P 3x5)
2Cover
5Out-polarizer (R) JSB assy or
Out-polarizer (R) JRB assy
3Screw
(+PSW 3x8)
Three flexible cables
8Screw
(+PSW 3x8)
9Rch in-polarization panel
Note on replacing the OUT-POLARIZER ASSY.
There are two combination methods when replacing the OUT-POLARIZER ASSY.
Check which one of the combination methods is to be used when replacing
the OUT-POLARIZER ASSY. (Refer to 4-11)
VPL-FX52/FX52L
2 C board
CN5302
CN5307
CN5305
CN5601
CN5306
CN5801
CN5103
CN5303
CN5304
6Out-polarizer (G) JSB assy or
Out-polarizer (G) JRB assy
7Out-polarizer (B) assy
4Prism block (G) assy
Note : Use extreme care not to touch the glass
section of prism, LCD, and conductive
section of the flexible cable in particular.
!/Screw
(+PSW 3x8)
!-Gch in-polarization panel
!= Screw
(+PSW 3x8)
![ Bch in-polarization panel
1-5