Honda NAVI 2016 Owner's Manual page 58

installation, see your Honda dealer as soon
as possible to verify proper assembly.
Change the engine oil from the engine
at normal operating
the vehicle on its center stand to assure
complete and rapid draining.
1. Start the engine and let it idle for 3-5
minutes.
2. Stop the engine. Turn the ignition off
and to be on safer side remove the
ignition key from ignition switch.
3. Place an oil drain pan under the crankcase.
Remove the oil filler cap/dipstick, oil drain
bolt (1) and sealing washer (2).
4. After the engine oil has been drained
out hold the vehicle upright for 10-15
seconds to assure complete draining.
5. Operate the kickstarter several times to aid
in complete draining of the remaining oil.
6. Check that the sealing washer (2) on the
drain bolt is in good condition and install
the bolt. Replace the sealing washer
every other time the oil is changed, or
each time if necessary.
50
temperature and
Oil Drain Bolt Torque:
24 N.m (2.5 kgf.m, 18 lbf.ft)
7. Fill the crankcase with recommended
grade oil;
0.7L (0.7 US qt, 0.6 Imp qt)
8. Reinstall the oil filler cap/dipstick.
9. Start the engine and let it idle for 3-5
minutes.
10. Stop the engine and wait 2-3 minutes.
Check that the oil level is at the upper
level mark on the dipstick with the
vehicle upright on firm, level ground.
Make sure there are no oil leaks.
(1)
¼vkW ; y Mª s u cks Y V½
(1) Oil drain bolt
(2) Sealing washer ¼lhfya x ok"kj½
Honda Motorcycle & Scooter India Pvt. Ltd.
(2)