Sony HDR-SR11 Service Manual page 11

1-3-2. E : 62 : 11 [Shift Lens Overheating (Pitch)] Occurred
Connect by the SeusEX and perform the following process.
Order Block Page Address Data
1 11 80
2 11 8E
3 11 8E
4 11 8E
5 11 8E
6 11 8E
7 11 8E
8 11 80
9
10
11
12
13
14
Note 1: Finish this operation within 10 seconds. If it is likely to take more than 10 seconds, set block: 11, page: 8E, address:
F948, data: 00, and then retry.
Note 2: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
HDR-SR11/SR11E/SR12/SR12E_L2
7430 01 Write the data. (After it starts, set it before caution is displayed.)
F946 F0 Write the data.
F948 01 Write the data. (Note 1)
F948 00 Write the data.
F946 10 Write the data.
F948 01 Write the data. (Note 1)
F948 00 Write the data.
7430 00 Write the data.
Check if the shift lens moves while setting the order 2 to 7. If the shift lens does not move,
replace the lens block (Note 2). When the shift lens moved, proceed to the order 10.
While setting the order 2 to 7, measure with an oscilloscope the output voltage of R5526 in the
periphery of IC5501 on the LD-230 board to check the output voltage varies.
If the output voltage does not vary, replace the lens block (Note 2). When the output voltage
varied, proceed to the order 12.
Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501
on the LD-230 board, turn the power ON to check that the output voltage immediately after the
power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note 2). If it does not
change as shown in Fig. 2, inspect the camera control circuit (IC1301 of VC-516 board)
periphery.
Procedure
1-4
ENGLISH JAPANESE
ENGLISH JAPANESE