General Information On Recording; Synchro Start Cd Recording; Recording From The Radio; Recording From The Aux - Philips MC-V320 User Manual

Tape Operation/Recording
General information on
recording
G Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
G For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
G The best recording level is set automatically.
Altering the VOLUME, DBB or INTERACTIVE
SOUND controls will not affect the recording in
progress.
G At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
G To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.

Synchro start CD recording

1
Select CD source.
2
Insert a disc and if desired, program track
numbers.
3
Press to open the tape door.
4
Insert a suitable tape into the deck and close the
tape door.
5
Press REC to start recording.
➜ REC is shown during recording.
➜ Playing of the CD program starts
automatically from the beginning of the CD
after 7 seconds. It is not necessary to start the
CD player separately.
To stop recording, press STOP 9.
6

Recording from the radio

1
Select TUNER source and tune to the desired
radio station (see "Tuning to radio stations").
2
Press to open the tape door.
3
Insert a suitable tape into the deck and close the
tape door.
4
Press REC to start recording.
➜ REC is shown during recording.
To stop recording, press STOP 9.
5
Recording from Aux
1
Select AUX source.
2
If necessary, prepare the additional appliance for
recording.
3
Press REC to start recording.
➜ REC is shown during recording.
To stop recording, press STOP 9.
4

Recording timer

To record from the radio, you will need to use a
preset radio station and to set a start (ON) and
finish (OFF) time.
1
Insert a suitable tape into the deck.
➜ If desired, press PROG/ REV to select tape
reverse mode option.
PLAY 1 SIDE : for recording one side only
PLAY A AND B : for recording on both sides
REPEAT A AND B : for recording on both sides
2
Select TUNER SOURCE and the preset radio
station to record from.
3
Press STANDBY ON to switch the system to
standby mode. Press TIMER SET /
than 2 seconds.
➜
flashes and a source is displayed.
4
Press SOURCE repeatedly, until REC TUN
source is displayed.
5
Press TIMER SET /
➜ SET ON TIME is displayed,
digits for the hours flash.
6
Press VOLUME –/+ to set the hours.
7
Press TIMER SET /
➜ The clock digits for the minutes flash.
8
Press VOLUME –/+ to set the minutes.
9
Press TIMER SET /
time.
➜ SET OFF TIME is displayed,
clock digits for the hours flash.
10
Repeat steps 6-8 to set the finish time.
11
Press TIMER SET /
settings.
➜
is shown and the recording timer is now
set.
for more
to confirm the source.
and the clock
again.
to confirm the ON start
and the
to confirm the timer
23