1. Manuals
  2. Brands
  3. Sunheat Manuals
  4. Patio Heater
  5. PHTR-LED
  6. Owner's manual

Sunheat PHTR-LED Owner's Manual

Outdoor patio heater
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ANSI Z83.26-2014/CSA 2.37-2014 Gas-Fired Outdoor Infrared Patio Heaters
Owner's Manual
OUTDOOR PATIO HEATER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from the appliance and
immediately call your gas supplier or fire department.
WARNING indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
An LP-cylinder not connected for use shall not be
stored in the vicinity of this or any other appliance.
WARNING:
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, injury or death.
Read the installation, operation and maintenance
instructions thoroughly before installing or servicing this
equipment.
R
1
MODEL #PHTR-LED
DANGER
WARNING
WARNING
For Outdoor Use Only
WARNING
C
R
R
US

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PHTR-LED and is the answer not in the manual?

Questions and answers

Related Manuals for Sunheat PHTR-LED

Summary of Contents for Sunheat PHTR-LED

  • Page 1 Owner’s Manual OUTDOOR PATIO HEATER MODEL #PHTR-LED DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your gas supplier or fire department.

  • Page 2: Package Contents

    PACKAGE CONTENTS Reflector Mesh Glass Tube Fixer Top Plate Upper Support (Long) Protective Guard Glass Tube Side Panel Black Silicone Ring Control Box Assembly Lower Support (Short) Block Belt Gas Hose & Regulator Wheel Assembly Bottom plate Front Panel Ceramic Fiber Led controller PART DESCRIPTION...

  • Page 3: Safety Information

    HARDWARE CONTENTS (shown actual size) Wing nut Stud Small Flat M5 x 12 mm Screw M6 x 12 mm Bolt Qty. 3 Qty. 3 Washer Qty. 35 Qty. 8 Qty. 6 Chain M4 x 10 mm Knob Qty.1 Screw Qty. 1 Fixing Bracket Qty.1 Qty.

  • Page 4: Service Safety

    SAFETY INFORMATION DANGER DANGER • EXPLOSION - FIRE HAZARD • CARBON MONOXIDE HAZARD • Keep solid combustibles, such as building materials, • This heater is a combustion appliance. All paper or cardboard, a safe distance away from the combustion appliances produce carbon monoxide heater as recommended by the instructions.

  • Page 5: Burn Hazard

    SAFETY INFORMATION WARNING WARNING California Proposition 65 • This product is fueled by propane gas. Propane gas Combustion by-products produced when using is invisible, odorless, and flammable. An odorant is this product contain chemicals known to the State normally added to help detect leaks and can be of California to cause cancer, birth defects, and described as a “rotten egg”...
  • Page 6 ASSEMBLY INSTRUCTIONS 1. Insert the hoods of bottom plate (O) to the lower holes of the three lower supports (K) Insert the hoods of control box assembly (J) to the upper holes of the three lower support (K). Note: Make sure align the side of bottom plate (O) with the holes with the side of control box assembly (J) with the magnet.
  • Page 7 ASSEMBLY INSTRUCTIONS Use Phillips screwdriver (LL) to fasten the control box assembly (J) and the bottom plate (O) with M5 x 12 mm screws (DD). Hardware Used M5 x 12 mm Screw Phillips Screwdriver 4. Use Phillips screwdriver (LL) to secure the top plate (D) to the upper supports (E) with M5 x 12 mm screws (DD).
  • Page 8 ASSEMBLY INSTRUCTIONS Using wrench (KK) to assemble the wheel assembly (N) to the bottom plate (O) with M6 x 12 mm bolts (EE). Hardware Used M6 x 12 mm Bolt Wrench 6. Use Phillips screwdriver (LL) to secure the block belt (L) to the lower supports (K) with M5 x 12 mm screws (DD).
  • Page 9 ASSEMBLY INSTRUCTIONS 7. Carefully install the glass tube (G) between the center of top plate (D) and control box assembly (J). Make sure the end of the glass tube (G) is inserted securely into the three clips of the control box assembly (J). Assembly the glass tube fixer (C).
  • Page 10 ASSEMBLY INSTRUCTIONS 9. Use Phillips screwdriver (LL) to install side panels (H) to bottom of assembly with M5 x 12 mm screws (DD). Note: Do not cover the panel where the magnet is. Hardware Used M5 x 12 mm Screw x 12 Phillips Screwdriver...
  • Page 11 ASSEMBLY INSTRUCTIONS 11. Assembly the protective guard and mesh Insert the hooks of protective guard (F) to the holes of upper supports (E). Put the mesh (B) on the top plate (D). Make sure the screw holes align the holes of top plate (D). Use Phillips screwdriver (LL) to secure the mesh (B) and protective guard (F) to the top...
  • Page 12 ASSEMBLY INSTRUCTIONS 13. Connect regulator to cylinder. Install cylinder, and secure with the propane block belt tightly. Complete installation. Note: The propane gas and cylinder are sold separately. Warning: Use a standard 20 lb. propane cylinder only. Use this heater only with a propane vapor withdrawal supply system.
  • Page 13 ASSEMBLY INSTRUCTIONS LED belt box and battery box installation. 14-1. The normal position of block chip like figure a. 14-2. Adjust the position of block chip like figure b. Pull out the LED belt box. 14-3. When changing the batteries, first take out the LED belt box and then battery box, after that open the battery box and...
  • Page 14 ASSEMBLY INSTRUCTIONS Operation Instructions of Controller 1. Specifications: Working temperature:-20-60℃ Supply voltage: DC12V Product size: L62×W35×H23mm Package size: L105×W65×H55mm Net weight: 50g Gross weight: 70g Output: Three CMOS drain-open Connecting Mode: Common anode Max Load current: 2 A each color 2.Control Method: Adopt IR remoter to control the led controller, which has 24 buttons, the function of each button as the table below:...
  • Page 15 ASSEMBLY INSTRUCTIONS Warning: A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your propane supplier. Never use a propane cylinder with a damaged valve connection. The propane cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S.
  • Page 16 OPERATION INSTRUCTIONS Leak Check WARNING • Perform all leak tests outdoors. • Extinguish all open flames. • NEVER smoke while carrying out the leak test. • Do not use the heater until all connections have been leak tested and do not leak. Hose / Regulator connection Regulator / Cylinder...

  • Page 17: Carbon Monoxide Hazard

    OPERATION INSTRUCTIONS DANGER • CARBON MONOXIDE HAZARD • For outdoor use only. Never use inside house, or other unventilated or enclosed areas. This heater consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life. Caution: Do not attempt to operate until you have read and understand all General Safety Information in this manual and all assembly is complete and leak checks have been performed.
  • Page 18 OPERATION INSTRUCTIONS 4. Push and release the igniter button until pilot flame is visible through the glass tube. 5. Once the pilot is lit, continue to depress the control knob for 30 seconds. 6. If the pilot does not stay lit, repeat steps 4 to 6. 7.

  • Page 19: For Your Safety

    OPERATION INSTRUCTIONS WARNING FOR YOUR SAFETY Be careful when attempting to manually ignite this heater. Holding in the control knob for more than 20 seconds before igniting the gas will cause a ball of flame upon ignition. When heater is ON: The flame should be blue with straight yellow tops.

  • Page 20: Care And Maintenance

    OPERATION INSTRUCTIONS 9. Heater is away from gasoline or other flammable liquids or vapors. 10. Heater is away from windows, air intake openings, sprinklers and other water sources. 11. Heater is located at least 24" (top) / 36" (sides) from combustible materials. 12.

  • Page 21: Troubleshooting

    TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Cylinder valve is closed Open valve Clean or replace orifice or Blockage in orifice or pilot tube pilot tube Pilot won’t light Open gas line and bleed it Air in gas line (pressing control knob in) for no more than 1 - 2 minutes or until you smell gas Low gas pressure with cylinder valve...
  • Page 22 CARE AND MAINTENANCE Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles. Carbon deposits may create a fire hazard.

  • Page 23: Replacement Parts List

    REPLACEMENT PARTS LIST Reflector Mesh Glass Tube Fixer Top Plate Upper Support (Long) Protective Guard Glass Tube Side Panel Black Silicone Ring Control Box Assembly Lower Support (Short) Block Belt Gas Hose & Regulator Wheel Assembly Bottom plate Front Panel Ceramic Fiber Led controller PART...

  • Page 25: One-Year Limited Warranty

    If a part (excluding light bulbs and fuses*) within one year from the date of purchase proves to be defective in material or fabrication under normal use, the part will be repaired or replaced. SUNHEAT International’s obligation under the warranty is to replace or repair defective parts at our discretion. Any expenses or damage resulting from the installation, removal or transportation of the product will be the responsibility of the owner and are not covered by this warranty.

Table of Contents