Tape Operation / Recording; Tape Playback; General Information On Recording; Synchro Start Cd Recording - Philips MC-122 Manual

Tape playback

1
Select TAPE source.
➜ The display shows TAPE throughout tape
operation.
2
Press STOP•OPEN to open the tape door.
3
Insert a recorded tape and close the tape door.
G Load the tape with the open side downward and
the full spool to the left.
Press PLAY 2 to start playback.
4
5
To interrupt playback, press PAUSE. To resume,
press this key again.
6
By pressing à or á on the system fast winding
of tape is possible in both directions.
7
To stop the tape, press STOP•OPEN.
G The keys are automatically released at the end of
the tape, except if PAUSE has been activated.
Note:
– The sound source cannot be changed while
recording a tape.

Tape Operation / Recording

General information on
recording
G Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
G For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
G The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND, DBB or INTERACTIVE SOUND
controls will not affect the recording in progress.
G At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
G To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.

Synchro start CD recording

1
Select CD source.
2
Insert a disc and if desired, programme track
numbers.
3
Press STOP•OPEN to open the tape door.
4
Insert a suitable tape into the deck and close the
tape door.
5
Press RECORD to start recording.
➜ Playing of the CD programme starts
automatically from the beginning of the CD
after 7 seconds. It is not necessary to start the
CD player separately.
To select and record a particular passage
within a track:
G Press and hold down on PREV ¡1 or NEXT
2™ (on the remote control à or á ).
G When you recognise the passage you want,
release PREV ¡1 or NEXT 2™.
G To interrupt disc playback, press PLAY•PAUSE
2; (on the remote control 2;).
G Recording will begin from this exact point in the
track when you press RECORD.
17