Alternatively, you may use the screws and wall
anchors supplied with the Accelerator Kit.
3. Tighten the screws until the antenna is firmly
mounted against the building.
3.4 - Running the Cable
If you are mounting the CM288-W antenna near
the roof of the building, you may want to run the
CM240-20 cable(s) underneath the edge of the
roof flashing. You may also choose to follow the
AUTHORED BY ANTHONY HERNANDEZ (415)786-2081 - anthony94122@outlook.com
route of existing cables such as satellite TV or tele-
phone lines.
1. Connect the male (large) end of the CM240-20
FN cable to the antenna by placing the cable
end over the antenna connector and tighten-
ing the screw collar clockwise until hand tight.
2. Run the cable along the outside of the build-
ing to where you want to run it inside. Please
see Section 3.5 if you need to connect both
CM240 cables.
Copyright 2011 Cellphone-Mate, Inc. All rights reserved.
CHAPTER 3: Installation
11