Page 2
Volume Control Mute Button III. Ear Cushion Mounted on Earplate D. Flexible Microphone Boom E. Microphone with Foam Cover F. Battery G. Battery Adapter H. Quick Disconnect Coil Cord I. Clothing Clip J. Wall Hook K. Optional Activa Headset/Handset Switch...
Connecting to your telephone 1. First, connect the headset cord to the Quick Disconnect coil cord. (Figure 2) 2. If your telephone has a socket for a headset connection, insert the modular plug at the end of the headset cord into the headset port on the telephone. If your telephone does not have a port for a headset connection, disconnect the handset cord from the telephone.
Inserting the battery 1. The battery chamber is located on the side of the receiver. To open the battery chamber, use your fingernail to pull the small flap up. (Figure 5) 2. When open, remove the chamber from the headset. (Figure 6) 3.
Page 5
Set up IMPORTANT: You must complete the following two steps before operation. You only need to follow these steps once for your phone. If, however, you use a different phone, you will need to repeat these steps. Step 1: Adjusting to your telephone C D E 1.
Page 6
Step 2: Adjusting the microphone sound level The microphone sound level must be set according to your model of telephone for the party on the other end to hear you clearly. This typically only needs to be adjusted once during set-up. 1.
Using the Headset After you have completed Steps 1 and 2 above, you are now ready to use your headset. Answering and Making calls 1. To answer or make a call, put on the headset, remove the handset from its cradle, and press the mute or the volume button.
Page 8
Adjusting for your comfort 1. You can wear the headset on your right or left ear, whichever side you prefer. To switch sides, simply rotate the microphone boom below the headband. Note: Do not force the boom over the top of the headset. (Figure 18) 2.
Troubleshooting The headset beeps every 10 seconds: • Replace the battery. People have a hard time hearing me: • Adjust the microphone positioning (refer to page 8, number 3). • Increase the microphone sound level (refer to page 6). The noise-canceling does not seem to be working: •...
FCC Notice to Users Upon request only, you must notify your telephone utility company (telco) of your intention to install or permanently remove an FCC Part 68 registered device or system. Include the FCC Registration Number and the Ringer Equivalence Number (REN) located on the amplifier label. The telco has the right to make changes to their network, which may affect the operation of your equipment, provided you are given adequate advance written notice to permit correct operation.
Warranty GN Netcom, Inc. warrants these products against all defects in material and workmanship for a period of two years from the date of original purchase. The conditions of this warranty and our responsibilities under this warranty are as follows: •...
Page 12
77 Northeastern Blvd. • Nashua, NH 03062 USA 1-800-826-4656 • www.gnnetcom.com 54-0022A Printed in USA November 1999...
Need help?
Do you have a question about the ACTIVA and is the answer not in the manual?
Questions and answers