Polymaker Polysher Operation Manual page 13

4
Open the chamber
Once the clearing cycle has completed, you
can press the Open/Close button to raise the
lift mechanism and your smoothed part.
5
Dry the part
You can now remove the platform from the
Polysher . Do not touch the part yet as the
TM
surface may be sticky and you may leave
finger marks on the part. The part should be
left to dry for about an hour before gentle
handling. You can use the other platform to
polish another part, if needed.
6
Install the Reservoir Cover
If you do not plan to use your Polysher again
in the near future, we recommend exchanging
the grate cover with the solid cover to inhibit
solvent evaporation, avoid vapor buildup
in the chamber, and prevent the nebulizer
sponge from drying out. If the nebulizer is left
uncovered for several days, the sponge may
dry out and require re-priming.
13